Gem sensors Series Ultrasonic Level Sensor
High Performance Ultrasonic Switch with Explosion-Proof Housing
Quick Specs...
- 10 Amp Relay Output
- 115/230 VAC 12 VDC or 24 VDC Input
- High Gain
- No Calibration Necessary
- Temperatures to 300°F (149°C)
- Lengths to 99 inches (251.5 cm)
Overview / Design Principle:
The ULS-10 Series features a Tip Gap probe design for closer tank bottom access. The miniaturized, encapsulated electronic control unit may be supplied for remote mounting, or directly mounted on sensor in an explosion-proof, NEMA enclosure. FM-Approved, explosion-proof enclosures are also available.
Gems ULS Series of ultrasonic switches are designed for a broad spectrum of viscous light liquids including some of the most challenging liquids you may deal with: acids, freon, paints, lacquers, etc. They're built to withstand high-temperatures and pressures with welded stainless steel sensor probes that have no seals to leak and no moving parts to wear out. ULS Series switches are unaffected by variation in temperature, pressure, density or type of liquid. In most cases, electronics are housed in cast aluminum, NEMA 4/NEMA 7 explosion proof and water tight enclosures.
Dimensions:
|
A |
3/4" NPT Thread Hub |
B |
3/4" NPT |
C |
2-1/2" (63.5 mm) m" |
D |
7/8" (22.2 mm) |
E |
4.0" (101.6 mm) |
F |
3-3/4" (95.2 mm) |
|
|
|
A |
3/4" NPT |
B |
2-1/2" (63.5 mm) m" |
C |
7/8" (22.2 mm) |
D |
4-1/2" (114.3 mm) |
|
|
Mounting and Sensor Materials
|
316 Stainless Steel (Standard); Consult Factory for Other Materials
|
* Flanges also available; consult factory for sizes and materials. |
|
Switch actuation level (L1) is determined following the guidelines below.
|
L1 |
2-1/4" (57.2 mm) Minimum
99" (251.5 cm) Maximum** |
A |
1/4" (6.4 mm) |
|
|
**Consult factory for longer lengths
Specifications: |
Input Power
|
115/230 VAC, 50/60 Hz; or 12/24 VDC
|
Gain
|
500:1
|
Output
|
10 Amp DPDT Relay, or 2-Wire, 4mA-Dray, 20mA-Wet (9-36 VDC)
|
Delay (On)
|
0.5 Seconds
|
Repeatability
|
2mm, Typical
|
Housing
|
NEMA 4/NEMA 7 Watertight, Explosion Proof Enclosure, Epoxy Coated Cast Aluminum Class I, Group C & D; Class II, Group E, F & G; Class III, Division 1 & 2
|
Operating Temperature
|
Sensor: -40°F to +300°F (-40°C to 149°C)
Electronics: -20°F to +170°F (-29°C to 77°C)
|
Pressure, PSIG, Max.
|
1000 @ 250°F
|
|